|About||Discount Graphics decals & more|
Custom made decals
HERE ARE YOUR INSTRUCTIONS ON HOW TO APPLY YOUR DECAL
**** Upon receiving your decal in the mail - unroll the decal and layout flat. Lightly squeegee out any wrinkles caused by the shipping process with a squeegee or old credit card. These wrinkles are normal and can not be avoided. You must squeegee them out before you start.
We STRONGLY suggest that you watch "How to apply vinyl graphics" videos online FIRST!
We no offer "how to install" videos on our facebook page.
Squeegee or credit card. (to apply pressure when installing decal) ***NOT INCLUDED***
Application spray (4 drops of dish soap mixed with water in a spray bottle)
Clean the area where decal will be applied with a lint free rag and Isopropyl Alcohol (rubbing alcohol). <---VERY IMPORTANT *DO NOT* USE WINDEX OR GLASS CLEANER-- USE RUBBING ALCOHOL ONLY!!!!!
Surface temperatures should be between 60 and 90 degrees Fahrenheit before attempting the installation. Applications outside the recommended range of 50 to 90 degrees Fahrenheit reduce the adhesives' ability to perform. DO NOT APPLY IN DIRECT SUNLIGHT!
You can choose to apply vinyl in one of two ways; dry or wet. Applying vinyl graphics dry does not allow for ANY mistakes. Once the vinyl touches the surface, there is no removal without damage. We suggest the wet method.
DRY METHOD- Simply clean the area where decal will be applied with rubbing alcohol. Then removing backing of decal. Then put decal on where you want it. Make sure you press the decal on firmly. Then squeegee the decal with firm pressure in all directions. Once decal appears fully adhered, SLOWLY remove transfer tape. If pieces of decal life, lay transfer tape back down and repeat process.
WET METHOD- Applying vinyl graphics with application spray allows you the opportunity to remove and reposition vinyl as needed for up to several minutes. For obvious reasons, this method is recommended for both beginners and experts. Position your decal